An easy way to handle And Fix ink cartridges that do not come out
Have you ever had a printer that does not come out when the ink used to print? Usuallythis occurs after the printer is not been used. Why did it happen? Not out of ink while printing because the ink on the head where the ink through the hole and sprayedclogged. Blockage is largely due to the dryness of the ink at the head end. So although the actual content of the ink cartridge, it still will not come out because head clogged.Continue how to overcome this?
Is actually quite easy. The key is that we should throw that block the ink dried on thehead. The steps are as follows:
1. Prepare a warm water first. What is the temperature? Guessed it, the important thing is not too hot and not too cold, too. If it is too hot can cause the head to be damaged, if it is too cold will be more difficult in removing the blockage. If confused, just mix hot and coldwater 50%: 50%
2. If so, prepare a cartridge to be removed the blockage. Find the head. The head is the part where the ink discharge, usually made of brass and yellow. If you still do notknow ya I think worse.
3. If you have found, slowly dip the head into the water is warm while rocking the baby. It is intended that the dried ink can fade faster. Note also the color of the water. Usually it willquickly turn black (due to the ink of course). If you've turned into a very dark, it helps youchange again with new water, then dip again headnya.
Note: You do not have to worry about going surge (short circuit), because it has a lot ofuse and proven.
Note: You do not have to worry about going surge (short circuit), because it has a lot ofuse and proven.
4. Do this several times until the ink can exit smoothly. So the water will be much faster turn black as the ink that comes out of the head.
5. If the water does not change the color cartridge is still clogged even mean because no one could come out of ink. This happens on a cartridge that has not been used very long(more than 1 year), and most likely not to be fixed, because it's clogging the ink was already dry.
If the blockage of the melting process is considered sufficient, then the cartridge isimmediately dry with a soft cloth or tissue.
6. Having done the above steps, then you can try again using the cartridge for printing, inkhopefully get out. If at the time of soaking the ink has come out smoothly, but once installed on the printer still is not out of ink, then there is the possibility of ink level sensorwas disabled. Usually occurs by the user and printer canon Pixma series. to restore theink level sensor there own way and I will post the next article.
An easy way to handle And Fix ink cartridges that do not come out
4/
5
Oleh
Agus Prasetyo
